cold shut
英 [kəʊld ʃʌt]
美 [koʊld ʃʌt]
冷疤；冷隔；冷结；（锻件上的）冷疤
双语例句
- Due to the cold weather, the silver iPhone 6 shut off and froze following launch.
由于天气寒冷，东北银爱疯6在着陆后关机并冰冻了。 - Sometimes, it is true, a sense of isolation enfolds me like a cold mist as I sit alone and wait at life's shut gate.
有时候，一种与世隔绝的无助感也会将我裹挟，如同将我抛进一股寒冷的雾霭当中，我孤独地坐在那道关闭的生命之门面前苦苦等待。 - When he tried accessing their traumas in therapy, they often became jittery, broke into cold sweats or shut down.
当他在治疗中试图触及他们的创伤时，他们往往一下子就变得如同惊弓之鸟一般，浑身冷汗涔涔或者将自己完全封闭起来。 - I've had a bad cold, and been shut up a week.
我得了重感冒，在屋里关了一个星期了。 - This usually takes place during the freezing cold months of winter when people shut all the windows and doors to keep out the biting wind while taking a hot bath.
这尤常发生在严寒的冬天，这时人们洗热水澡时会紧关门窗，以抵挡刺骨的寒风。 - She said that it was cold there and asked if the window was shut.
她说那儿很冷，并问窗户是否关了。 - The results showed the applied pressure is beneficial to eliminate grainy surface and cold shut because of improving filling ability.
加压后提高了铝液充型能力，有利于消除铸件表面的颗粒状和冷隔； - The lower specific pressure and delay pressurization in time during casting process were responsible for surface blister and cold shut of motor cycle wheel in squeezing casting.
分析了实际铸造比压偏小以及不能瞬间及时增压是造成摩托车车轮挤压铸件表面起泡和冷隔的主要原因。 - Simulated results show that obtained parts has few defects, such as inclusion and cold shut due to smooth mold filling and uniform distribution of temperature field.
模拟结果表明，该浇注系统填充过程平稳，温度场分布均匀，所得压铸件气体夹杂和冷隔缺陷少，整体质量较高。 - Then, the limit speeds of cast drawing were calculated according to the main technical defects, i.e. the cold shut and the solid break, the calculation value corresponded with the measured results.
然后根据限制铸拉速度的主要缺陷，即凝固壳断裂和冷隔，通过计算铸件截面承受的摩擦力、热应力和液穴形状，得到了铸拉工艺的极限速度，计算值与实测值吻合。 - By coupling simulation of fluid field and temperature field, the location and cause of the defects such as misrun, cold shut, material property are exposed.
通过对流动场温度场的耦合计算，揭示了铸件产生冷隔浇不足、材质等缺陷的部位与形成原因。